Exit Actuator & Sensor
Fuser Assembly
Front Cover
Chute Assembly In
Transfer Roller
Imaging Unit
Return to Xerox Phaser 6200 Parts & Supplies Page
Resolving Xerox Phaser 6200 Error Codes
Get in touch with one of our knowledgeable support staff by phone, email or IM for FREE and LIVE technical support on this or any Xerox printer.
Phone :1-800-367-4836
Email : wrinaldo@iteminc.com
AOL IM: TEKTRONIXPARTS
Jam at Fuser
Check the following parts for evidence of fault or damage and replace any parts that appear to not function correctly:
|
Exit Actuator & Sensor |
|
Fuser Assembly |
|
Front Cover |
|
Chute Assembly In |
|
Transfer Roller |
|
Imaging Unit |
Remove the Fuser and check for broken or bent pins.
Use service diagnostics to test the Exit Sensor. If the Exit Sensor is not functioning correctly, you will need to replace it with a new Fuser, 016-2014-00.
Finally, Use service diagnostics to test the Fuser Motor. Does the Fuser Motor function correctly? If the Fuser Motor IS functioning correctly, then replace the Engine Control Board, 116-1487-00. If the Fuser Motor IS NOT functioning correctly, then replace the Motor Driver Board and/or the Fuser Motor.
